Presets with the Config panel
The Config panel reads, edits and writes the module's 16 presets and global settings over USB, in Chrome or Edge. It never touches the calibration.
- Connect the module's USB port (on the Daisy Seed, at the back) to the computer.
- Open the Config panel and press Connect to module, then Read from module.
- Edit presets, or Save .bin to keep a backup.
- Write to module sends the edited presets back.
A .bin backup can be opened later with Open .bin… and written to any
ADDAC511.
Factory presets
To put the factory presets back on a module:
- Download ADDAC511_FACTORYpresets.bin.
- In the Config panel: Open .bin… and choose the file.
- Connect to module, then Write to module, and confirm. This replaces all presets on the module; calibration is kept.
Settings on the module
Press MENU for the options menu. Turn ENCODER A to move, push ENCODER B to enter, push ENCODER A to go back.
| Option | Choices | Default |
|---|---|---|
| SCREENSAVER | off / on, after 10 s, 1, 2 or 5 min | off |
| AUTO RETURN TO MAIN | on / off, after 10 s, 30 s or 1 min | on, 10 s |
| VCO TUNING | test voltages on the CV outputs | |
| CALIBRATE CV OUTS | fine-tune the CV outputs | |
| UPDATE FIRMWARE / UPDATE BOOTLOADER | see Programming |
The output order (CV before gate, or gate before CV) is set in the Config panel.
Power-up shortcuts
Hold the buttons while powering the module up:
| Hold | Does |
|---|---|
| MENU | starts with the default preset |
| MENU + STATE C | erases all presets (calibration is kept) |
| ENCODER A | starts in firmware update mode |